13-1133-51, Active system adapter Honda different vehicles, ACV

Amplified system adapter Honda

Metra 70-1730

Active system adapters maintain the function of an OEM amplified system.

This allows the connection of an aftermarket HU to an OEM amplified system while retaining the OEM amplifier and connected speakers by adapting, matching or converting the output signals of the signal source to the signal input of the OEM amplifier.

Depending on the vehicle and the installed OEM amplified system, various functions such as fader, sound or subwoofer settings might be lost.

In individual cases, depending on the OEM system and the retrofit radio, increased noise or a switch-on or switch-off noise may occur.

Check functionality before final assembly.

Note:

connector: 24 Pin Honda
connector: 8 Pin Honda > OEM Subwoofer

vehicles without Premium Honda OEM amplified system

vehicles with OEM Sat Nav > OEM subwoofer assigned differently if necessary*

yellow: +12V continuous current clamp 30
red: +12V ignition current clamp 15
black: Masse/GND clamp 31*
orange: +12V illumination clamp 51
orange/white: dimmer
blue: +12V antenna remote
blue/white: +12V Amp remote
black/white: GND clamp 31 OEM amplifier
brown: mute

Low-Level input:
Cinch(f) grey: rechts vorne
Cinch(f) white: links vorne
Cinch(f) purple: rechts hinten
Cinch(f) green: links hinten
Cinch(f) white 8 Pin: OEM Subwoofer

depending on the vehicle and equipment additional signals may vary

*16 Pin connector: Pin 3 Sub+ / Pin 11 Sub-
**car body GND direkt > if not connected

Vehicle application:

Honda Accord (CU1/CW1) 06/2008 - 04/2011
Honda Accord (CU1/CW1) 04/2011 - 06/2015
Honda Civic (FK) 02/2012 - 01/2015
Honda Crosstour 2010 - 2012
Honda CR-V (RE6) 11/2012 - 02/2015
Honda CR-Z (ZF1) 06/2010 - 12/2013

General installation instructions:

Connections, connection changes, alternative connections, connections of loose cables or connection extensions of loose cables specified in the information text or the manual are for orientation purposes only and for the information of trained specialist instaler.

Connections, changes to the cable configuration of the wiring harness or use of alternative connections or connection extensions:
1: Connections and changes are to be carried out exclusively by trained specialist installer.
2: Connections and modifications must be checked before connection for any manufacturer approvals or manufacturer warranty conditions that may be affected by the modifications.
3: Connections and modifications must be checked for function and correctness by measuring and comparing them with the vehicle's cable assignment diagram before connection.
4: Connections and modifications are made on the user's own responsibility without guarantee of function.
5: Connections and modifications are made on the user's own responsibility without any guarantee of damage to the vehicle, the retrofit device or the interface.
6: Modifications to the pre-assembled wiring harness may invalidate the product's warranty.